Amprobe DGC-1000A Clamp Ground Resistance Tester

• Accurate ground resistance measurement from 0.025 to 1500 Ohms
• True-rms current measurement including leakage current
• Accurate readings regardless of power quality in less than 10 seconds
• Air-tight jaw to enclose electrode or ground rod
• Continuity beep if the resistance is lower than 40.00 Ohms
• Simple and easy to use, no test leads or auxiliary electrodes necessary
• Data logging capability – 116 records
• Individual data point recording
• Display type 4 digits 9999 counts LCD
• Freeze value on screen
• User selectable high low ohm audible alarms
• Safety rating Category III 300 V and Category II 600 V
• Auto power off (can be disabled)
• Low battery indicator
• Large LCD display

User-Friendly And Accurate Tester

The DGC-1000A is a true RMS (root mean square) meter providing accurate readings when measuring linear or non-linear loads where the current or voltage has a sinusoidal or nonsinusoidal waveform. The clamp-on head enables the user to measure resistance on a ground rod in a multiground system without the use of auxiliary ground rods and without disconnecting the other grounds. The on-board memory and data logging features improve efficiency.

It's designed for use by electricians and electrical contractors for measuring ground resistance, current, and continuity in multi-grounded electrical systems.

• DGC-1000A
• Resistance calibration plate
• 9 V battery (installed)
• Carrying case